Klicka här för att ändra text
TO CHOOSE A RING BY MEASURING YOUR FINGER
Measure your finger in the evening when the near finger is at room temperature. Do not measure your finger when it is extra hot or cold. Remember that the hands differ in size; a ring worn on one of the fingers of the left hand will not fit perfectly on the same finger on the right hand. Make sure that the size you have chosen leaves room for the ring to easily slide the entire length of the upper finger and consider the size of the knuckle. You can use a tape measure to measure your finger. The circumference of the measuring finger in mm. This measure corresponds to the size of the ring. If you are in doubt between two sizes, choose the larger size. Note that the style of the ring will also affect the choice of size: a large ring should be worn looser than a smaller model, a wide ring sits years more than a narrow one. When using so-called. stacking rings, ie several narrow rings next to each other, so a looser dimension is required.
CHOOSE THE SIZE OF A BRACELET BY MEASURING ANOTHER BRACELET
Find a bracelet that suits you right. Lay it down flat. Measure with a ruler length from the top of the buckle to the end of the bracelet. Make a note of the measurement. Order your Cartier bracelet in one size as close to this size as possible.
CHOOSE THE SIZE OF A BRACELET BY MEASURING YOUR WRIST
Find a bracelet that suits you right. Lay it down flat. Measure with a ruler the length of the clamping stop to the end of the bracelet. Make a note of the measurement. Order your bracelet in a size as close to this measurement as possible. Different ways to measure your wrist: Use a measuring tape. Wrap the measuring tape around the wrist that you plan to wear your bracelet on. Note the number at the point where the tape meets the 0. Add 1.5 cm to make the bracelet sit comfortably. You can then add or subtract 1 centimeter depending on whether you prefer a loose, precise or tight fit. Download and print the Orrling Wrist Sizer. Before printing, until the "Page Scaling" option is set to "zero" in the dialog box, the Orrling Wrist Sizer must be printed on full-size A4 paper, follow the instructions and note your wrist size.
For best results, go to "Print Options" before printing and make sure the "Page Scaling" option in the print dialog is set to "zero". Orrling Wrist Sizer must be printed on a full size page (A4) To check that the wrist sizer has been written correctly, use a ruler to measure the sample in pdf, it should measure exactly 40 mm.
Manual for using Orrling Jewelery bracelet measurements
• Cut out the Wrist Sizer paper and follow the instructions below.
• Make sure the numbers are on the outside of the paper's Wrist Sizer and insert the pointed end notch you cut at the other end specified [cut here]. Place your hand through the Wrist Sizer and pull on the pointed end until it sits comfortably on your wrist.
• The number that is in line with the edge of the slot is your wrist size.
• You can also use a measuring tape; or if you do not have one, use a small piece of ribbon or rope. Wrap it around the wrist and measure the length with a ruler. Note that the wrist measurement is only a guiding guide and may therefore not be an exact measurement.
TO CHOOSE A NECKLACE
Use the Orrling-Jewelery measurement template for necklaces to determine the correct size of your necklace. The size depends on the model of the necklace and the fit you prefer.